Difference between revisions of "Rebuilding An Engine"

From Citroen SM Wiki
(Modifications to Make)
(Modifications to Make)
Line 15: Line 15:
 
* Drill 0.5mm oil spray hole onto primary chain. (See [[Primary Chain Oil Spray]])
 
* Drill 0.5mm oil spray hole onto primary chain. (See [[Primary Chain Oil Spray]])
 
* [[Oil Pickup Modification]]
 
* [[Oil Pickup Modification]]
* I've heard that Jerry Hathaway recommends removing a mil or so from the connecting rod big ends to improve crush on the bearings. [[User:Brucem|Brucem]] 19:48, 23 July 2008 (EDT)
+
* John Titus has demonstrated the feasibility of using main bearings from a Ford V8 (351M/400M) engine in place of the expensive ($800 ++) Vandervell main bearings.  The bearings fit the SM crankshaft out of the box.  The block must be line bored to accept the Ford bearings.  No other modifications are required, but do stamp block to inform rebuilders.   
* John Titus has demonstrated the feasibility of using main bearings from a Ford V8 (351M/400M) engine in place of the expensive ($800 ++) Vandervell main bearings.  The bearings fit the SM crankshaft out of the box.  The block must be line bored to accept the Ford bearings.  No other modifications are required.   
 
  
 
[[Image:Block with Ford Bearings web.jpg|300px|thumb|left|Maserati Block with Ford Bearings - John Titus photo]]
 
[[Image:Block with Ford Bearings web.jpg|300px|thumb|left|Maserati Block with Ford Bearings - John Titus photo]]

Revision as of 23:28, 17 January 2015

See also Engine

Things to do

  • New chains!
  • Fit solid exhaust valves. * See Sodium Filled Valves
  • Grease main oil galley O ring to timing cover
  • Clean Out Oil Feed Restrictors in Heads, one for each cam, 5 holes in each
  • clean out restrictors to front & rear bearings of the inter shaft (same as above).
  • Replace half moon seals at end of camshafts in head.

Modifications to Make

  • curved primary chain tensioner (See Primary Chain Tensioner)
  • Oil Pump Driveshaft and spacer
  • Drill 0.5mm oil spray hole onto primary chain. (See Primary Chain Oil Spray)
  • Oil Pickup Modification
  • John Titus has demonstrated the feasibility of using main bearings from a Ford V8 (351M/400M) engine in place of the expensive ($800 ++) Vandervell main bearings. The bearings fit the SM crankshaft out of the box. The block must be line bored to accept the Ford bearings. No other modifications are required, but do stamp block to inform rebuilders.
Maserati Block with Ford Bearings - John Titus photo


General Notes

  • Where to Buy Parts
  • A pleasant video from SM World on priming and starting a freshly rebuilt engine:

http://www.youtube.com/watch?v=XDWkx-XNpHc