Difference between revisions of "Primary Chain Oil Spray"

From Citroen SM Wiki
(OOTFAB Dual Primary chain oiling holes)
Line 20: Line 20:
 
Consider the simpler alternative of modifying the main oil passage in the primary cover to create two oil spray holes for the primary chain. Requires no modification of engine block. Requires only and angle drill and basic measuring skills.
 
Consider the simpler alternative of modifying the main oil passage in the primary cover to create two oil spray holes for the primary chain. Requires no modification of engine block. Requires only and angle drill and basic measuring skills.
  
[[Image:Thm_DSC03867.JPG|thumb|center|Spray Hole #1]] [[Image:Thm_DSC03865.JPG|thumb|center|Spray Hole #2]]
+
[[Image:Thm_DSC03867.JPG|thumb|center|Spray Hole #1]][[Image:Thm_DSC03865.JPG|thumb|center|Spray Hole #2]]
  
 
<br clear="all"/>
 
<br clear="all"/>

Revision as of 21:45, 19 April 2011

The original design of the engine did not provide a direct oil spray onto the primary chain. This may have contributed to the early wear of chains. While modern are significantly more durable than those originally fitted, it is possible to add the spray that Citroen fitted to all later engines and required on reconditioning. In order to locate the spray correctly, the following jig is required.


OilSprayDrillingJigPosition.jpg

Use of a cardboard replica jig to show general location

Picture of Spray Hole


Picture of spray hole (circled in white)

Spray hole is circled in white


OOTFAB Dual Primary chain oiling holes

Consider the simpler alternative of modifying the main oil passage in the primary cover to create two oil spray holes for the primary chain. Requires no modification of engine block. Requires only and angle drill and basic measuring skills.

Spray Hole #1
Spray Hole #2


Drawings of a Citroen/Maserati-designed jig to locate a drilling site

Page 1
Page 2

Combined PDF: OilSprayDrillingJig.pdf

The original factory-specified hole was 0.5mm. Citroen specifies 1.0mm in this jig, possibly because of the care needed with the smaller drill. This 'modified from the original' jig allows the hole to be drilled without completely stripping or removing the engine.




OOTFAB made jig:

Drilling Jig
Drilling Jig

(See Marketplace:OOTFAB for more information)